Serenelife safe manual

Serenelife safe manual DEFAULT

SLSFE11

Portable Electronic Safe Box

INSTRUCTIONS

1. TO PROGRAM AND CHANGE

THE USER CODE

a.

First, open the door of your safe,

without turning the rotary knob before

you start to program your safe.

Remove the battery compartment cover on the back of the door and

place the batteries (4x1.5 batteries type AA) into the battery holder

correctly. (Batteries included inside the safe).

b.

While the door is open, press the button behind the door. The yellow

light will be on with a short beep. Please input the user code (from 3-8

digits) using any number from "0" to "9" within 30 seconds, then press "E"

to con rm it.

c.

To change the user code, please use the same procedures as above.

2. TO OPEN THE SAFE

Input the user code you programmed, then press "E". The green light will

be on. Please turn the knob within 5 seconds and pull out to open the

safe. If a wrong digit is input, you can press "C" to cancel it.

Note: With each press the yellow light will ash with a short beep,

indicating that the micro processor con rmed it. If the yellow light keeps on

ashing with the beep, it means the code is wrong. Inputting the wrong

code three times will result in the micro processor refusing to accept the

input for 20 seconds. If you press the wrong code three times again, the

micro processor will refuse to accept input for 5 minutes.

3. TO CLOSE THE SAFE

Close the door and turn the knob counter-clockwise to lock the safe.

www.SereneLifeHome.com

Sours: https://www.manualslib.com/manual/1858090/Serenelife-Slsfe11.html

Models: SLSFE12 | SLSFE14 | SLSFE15

ELECTRONIC SAFE

USER MANUAL

OPENING YOUR SAFE FOR THE FIRST TIME

Upon rst use, users should open the safe with the

emergency key.

•To do this: Remove emergency lock cover, insert

the emergency key, and turn it counterclockwise.

•Turn the knob counterclockwise to open the door.

CAUTION: Finish operation, pull the emergency key out

and keep it in a safe place.

INSERTING THE BATTERIES

•Open the door with the emergency key

•Insert 4 X 1.5V batteries into the battery

compartment. Upon inserting, the buzzer will beep

and the green light will ash.

•If both green and red light are on, it indicates the

batteries are low and should be replaced.

SETTING USER CODE

•With the door open, press the reset button (the red

button on the battery compartment), input the 3- to

8-digit user code and press the “enter ”button or

the “lock” button.

•2 buzzer beeps with green light ashes indicates

the new user code is stored.

OPENING DOOR WITH USER CODE

Input your user code. After each press, the buzzer will

beep and the green light will ash, press the “enter”

button or the “lock” button. After the correct code is

entered, there will be 2 buzzer beeps and the green

light will ash, rotate the knob counterclockwise

within 5 seconds to open the door.

CAUTION: A wrong code input will activate 3 buzzer beeps.

CLOSING DOOR

Turn the knob clockwise to close the door.

MOUNTING METHOD

•Fix the safe in a place which is not easy to move.

•Drill holes for expansion bolts (or clamping screws)

in the right place.

•Turn the expansion bolts counterclockwise to

separate.

•Use the expansion bolts (or clamping screws) to

secure the case to the wall.

•Make sure the case is mounted in place as

required and then tighten screws.

CAUTION: Use the expansion bolt when there is a

concrete wall surface. Use the clamping screw when

there is a wooden wall surface.

AUTOMATIC LOCK

3 continuous wrong inputs will activate the warning

beep for 20 seconds.

Another 3 continuous wrong inputs will activate the

warning beep for 3 minutes.

CAUTION: The keypad will be disabled during the

beeping. You can only stop the beeps by opening the

safe with emergency key or removing the batteries.

Sours: https://www.manua.ls/serenelife/slsfe15/manual
  1. Zinc planter trough
  2. Dogs cuddling gif
  3. 2017 impala grill
  4. Fake viking beard
  5. Milkchoco game

SereneLife SLSFE15 manual

Page: 1

Models: SLSFE12 | SLSFE14 | SLSFE15 ELECTRONIC SAFE USER MANUAL OPENING YOUR SAFE FOR THE FIRST TIME Upon first use, users should open the safe with the emergency key. • To do this: Remove emergency lock cover, insert the emergency key, and turn it counterclockwise. • Turn the knob counterclockwise to open the door. CAUTION: Finish operation, pull the emergency key out and keep it in a safe place. INSERTING THE BATTERIES • Open the door with the emergency key • Insert 4 X 1.5V batteries into the battery compartment. Upon inserting, the buzzer will beep and the green light will flash. • If both green and red light are on, it indicates the batteries are low and should be replaced. SETTING USER CODE • With the door open, press the reset button (the red button on the battery compartment), input the 3- to 8-digit user code and press the“enter ”button or the“lock”button. • 2 buzzer beeps with green light flashes indicates the new user code is stored. OPENING DOOR WITH USER CODE Input your user code. After each press, the buzzer will beep and the green light will flash, press the“enter” button or the“lock” button. After the correct code is entered, there will be 2 buzzer beeps and the green light will flash, rotate the knob counterclockwise within 5 seconds to open the door. CAUTION:Awrongcodeinputwillactivate3buzzerbeeps. CLOSING DOOR Turn the knob clockwise to close the door. MOUNTING METHOD • Fix the safe in a place which is not easy to move. • Drill holes for expansion bolts (or clamping screws) in the right place. • Turn the expansion bolts counterclockwise to separate. • Use the expansion bolts (or clamping screws) to secure the case to the wall. • Make sure the case is mounted in place as required and then tighten screws. CAUTION: Use the expansion bolt when there is a concrete wall surface. Use the clamping screw when there is a wooden wall surface. AUTOMATIC LOCK 3 continuous wrong inputs will activate the warning beep for 20 seconds. Another 3 continuous wrong inputs will activate the warning beep for 3 minutes. CAUTION: The keypad will be disabled during the beeping. You can only stop the beeps by opening the safe with emergency key or removing the batteries.

Sours: https://www.manualscat.com/en/serenelife-slsfe15-manual
How to reset your Yale safe

User Manual SereneLife SLSFE24FP Electronic Fingerprint

SereneLife SLSFE24FP Electronic Fingerprint - Use Manual - Use Guide PDF.
Documents: Go to donwload!
  • Owner's manual - (English)

file thumbnail

Electronic Fingerprint User Manual SereneLife model SLSFE24FP

SET USER CODE

  • The safe on delivery comes with no registered fingerprints.
  • The safe is not loaded with batteries, you may insert the emergency key into the emergency keyhole to open the door .
  • Uncover the battery compartment cover at the back of door. And put in 4 X AA batteries. Please pay attention to the polarity of the batteries. For normal use, the batteries last up to one year.
  • The preset code of safe on delivery is "1234", the user may open the door with the preset code when batteries are placed and tested normal.

POWER SUPPLY

  • Pull the door open.
  • Pull out the battery compartment cover.
  • Replace 4 fresh batteries by lining them up in a manner as indicated by the "+" and signs.

NOTE: If the red light activates, it means the batteries are low. So you can plug the emergency battery boxes into the jack to power. While choosing batteries, it’s suggested to use high-powered, high quality alkaline batteries. Please do not use any inferior, counterfeit or carbon-zinc batteries.

NOTE: A maximum of 20 fingerprints can be registered.

NOTE: Factory preset code is 1234.

  • Press Initialization/Add key, and you’ll hear a short "Bleep, Bleep".
  • Put your finger at finger collector screen where the red light is. You’’ll hear "Bleep, Bleep" for two times.
  • After about a second, a long "Bleep" follows a short one, which meansthat fingerprint registration succeeded. (3 short "Bleep, Bleep, Bleep" means registration failed.)
  • According to this method, you can register other fingerprints.
  • Press number key "1" for about 5 seconds, the green indicator light will turn on. Input the current/original code and press the unlock key to confirm. After hearing a "Bleep", input new code (4 to 8 digits) and press the unlock key. Input the code again, and press the unlock key. Hearing a "Bleep" means the operation was successful.


Newest Added: SLSPGN10SLBTW60GSLBTW66GSLTS85SLTS98

Tags: SereneLife 3 Bow Bimini Top Canvas, Serene Life Electric Pump 10, Serene Life Digital Pump, Serene Life, Serene Life Air, Serene Life Paddle Board Instructions

SereneLife SLSFE24FP | Pages: 6 | Created on: 2016-05-19 | File type: PDF | Filename: 21624189_slsfe24fp.pdf | Size: 2.02 MB | Language: English

Download User Manual

Q: The safe did not indicate the battery was low and now it will not open and the key has been lost. Hoe can I open the safe
Reply


Copyright © 2021 ManualsFile.com. All rights reserved.

Sours: https://manualsfile.com/product/p7nf4d78i2.html

Manual serenelife safe

Models: SLSFE12 | SLSFE14 | SLSFE15

ELECTRONIC SAFE

USER MANUAL

OPENING YOUR SAFE FOR THE FIRST TIME

Upon rst use, users should open the safe with the

emergency key.

•To do this: Remove emergency lock cover, insert

the emergency key, and turn it counterclockwise.

•Turn the knob counterclockwise to open the door.

CAUTION: Finish operation, pull the emergency key out

and keep it in a safe place.

INSERTING THE BATTERIES

•Open the door with the emergency key

•Insert 4 X 1.5V batteries into the battery

compartment. Upon inserting, the buzzer will beep

and the green light will ash.

•If both green and red light are on, it indicates the

batteries are low and should be replaced.

SETTING USER CODE

•With the door open, press the reset button (the red

button on the battery compartment), input the 3- to

8-digit user code and press the “enter ”button or

the “lock” button.

•2 buzzer beeps with green light ashes indicates

the new user code is stored.

OPENING DOOR WITH USER CODE

Input your user code. After each press, the buzzer will

beep and the green light will ash, press the “enter”

button or the “lock” button. After the correct code is

entered, there will be 2 buzzer beeps and the green

light will ash, rotate the knob counterclockwise

within 5 seconds to open the door.

CAUTION: A wrong code input will activate 3 buzzer beeps.

CLOSING DOOR

Turn the knob clockwise to close the door.

MOUNTING METHOD

•Fix the safe in a place which is not easy to move.

•Drill holes for expansion bolts (or clamping screws)

in the right place.

•Turn the expansion bolts counterclockwise to

separate.

•Use the expansion bolts (or clamping screws) to

secure the case to the wall.

•Make sure the case is mounted in place as

required and then tighten screws.

CAUTION: Use the expansion bolt when there is a

concrete wall surface. Use the clamping screw when

there is a wooden wall surface.

AUTOMATIC LOCK

3 continuous wrong inputs will activate the warning

beep for 20 seconds.

Another 3 continuous wrong inputs will activate the

warning beep for 3 minutes.

CAUTION: The keypad will be disabled during the

beeping. You can only stop the beeps by opening the

safe with emergency key or removing the batteries.

Sours: https://www.manua.ls/serenelife/slsfe12/manual
Serene Life safe box review

Get out of bed, if only for a drink and a bite (they threw the child to his mother that evening) And Nastenka flew in after my visit, but only she can tell from whom, maybe this was also played by them, maybe she was already in flight as their second child from Andrei and just decided for more excitement to play a flight from another.

but she only managed to sit with her back resting on the leg of the table. I went up to her and called her. She raised her dull, drunken eyes to me and tried to say something.

You will also be interested:

Does something unimaginable to me. Without controlling myself, I emerged from the shower and began sorting through the bottles standing by the glass. Choosing a medium sized hairspray, I climbed back into the shower and sucked it greedily, The tight hemispheres of her buttocks parted to the sides. Ethan came in from behind and clasped Lisa's ass with his hands, drove a member into her wet slit.



3172 3173 3174 3175 3176